Tuesday, December 21, 2010

Prepare your ISCSI disk for use

When you want to run a HA solution with Failover Cluster using ISCSI, you need to prepare the disk for use. You need to initialize and format the disks presented by the ISCSI target form one of the nodes in the cluster. You do this on only one node in the cluster.
1.       In Server Manager select ‘Disk Management’. It should show the connected ISCSI-target disks as offline
2.       Right click each of the drives and select the Online option to bring them online. Right click again and select Initialize Disk.
3.       When the initialization is done, right click the unallocated space on a disk and select Create Simple Volume. Make the selections in the wizard to format the disk in the manner you want to formatted. Disks MUST be formatted as NTFS for use in a Failover Cluster. (You don’t need to assign a drive letter). Repeat these steps for every disk you want to use in your cluster.
4.       Right click each of the created disks and select Offline

Congrats. You`re now done. In addition: also follow these steps when creating a Guest Cluster using ISCSI.

2 comments:

yup said...

What in case the disk is not set to off line (as said in step4) because while I created a few clusters using Iscsi storage I left the disks as online after formatting and assigning drive letter (formatted at one node only).

Kristian Nese said...

The Failover Cluster wizard would normally bring the disk offline. When creating the cluster. I usually dont assign a drive letter since using CSV and the CSV are located under C:\ClusterStorage\Volume1 etc.
You only format and prepare the disk from one node - but it`s important that you have connected to the iscsi-target from every server in the cluster before assigning disk through the cluster wizard, or else it would fail.